Analog input
(reference: -10dBFS digital)
AOP: Analog output panel
This panel is used to output a selected channel of the TMS-network
on an 3pin XLRM connector front mounted. The channel can be
chosen by pushing the ‘up’ and ‘down’ buttons. The AOP needs to
be connected to an interface INT5500.
The output level is according underneath table.
AMP: Analog monitoring panel
This panel allows you to listen to a particular channel with the
headphones. A second unit on the AMP5500 provides two galvanic
separated outputs on which the volume regulated orator signal is
present. These outputs can be used as input of two PA-systems for
audio in the room.
Technical data
CPU5500
To Next Page
Loading...
