Page | 28
When more than 4 TMS branches (or 2 TIS branches), an extension
unit (EU5500) can be used. With the extension unit, 8 branches are
created. The extension unit is connected with the cental unit via a
regular TMS or TIS port and a clockport(*). The number of
extension units is unlimited.
(*) remark :
clock port connection only needed when roomcoupling is used
See also appendix F : EU- SPL connections
EU5500-L loop extension unit
When more than 4 TMS branches (or 2 TIS branches), an extension
unit (EU5500-L) can be used.With the extension unit, 4 loops are
created.The extension unit is connected with the cental unit via a
regular TMS or TIS port and a clockport(*). The number of
extension units is unlimited.
(*) remark :
clock port connection only needed when roomcoupling is used
See also appendix F : EU- SPL connections
AIP: analog input panel
This panel is used to send an analog audio signal on the floor
channel. The ON/OFF button enables or disables the audio input.
The AIP needs to be connected to an interface INT5500.
The input level can be adjusted by using the turn-knob of the panel.
The input sensitivity can be controlled by means of the jumper
adjustment.
Jumper adjustment
To Next Page
Loading...
