Page | 14
Table top units
Interphone: the handsets (IHS5500)
The connection must always be done on a MIC and DCS port with
the same number! Four interphone handsets can be connected to
one interface.
Encoder settings
To set the intercom number of the handset you need to adjust two
rotary switches on the circuit board. Carefully remove the bottom
plate by unscrewing the screw at the top of the handset, under the
hook. The bottom of the circuit board is showed on the picture
below.
Notice the two RJ45 connectors to connect the handset in the TMS
network and the two rotary DIP switches. The switch on the left is
used to set the units of the intercom number. The other switch sets
the decimals.
For example:
The following setting will result in an intercom number 16.
The maximum allowed number depends on the version of the
IHS5500 system. The most recent version (1.02) supports the
numbers 1 to 79 while the older version (1.01) only supports the
numbers 1 to 19.
To Next Page
Loading...
