Televic TCS5500 - Fault Detection; PC Communication Tests

Page | 76
Fault detection
Survey
When the installation is not correctly put into service, the following
faults to be divided in two major groups must be detected:
There is still communication with the operation PC
For the TMS system some tests can be done. These tests show
possible defects in the room.
 Test generator: play a sound in headphones and
loudspeakers
 Microphone test: all microphones will be activated one after
another.
 Hardware test: general hardware test for micro LEDs, vote
LEDs, LCD and loudspeakers.
 Diagnostic:
Info CPU: check the LED status on the CPU
- logging
Log mode 42
: gives a list of what is connected on the TMS
network (INT in order  CPU5500)
Log mode 41
: gives a list of what the CPU5500 send to the
interfaces during initialization (CPU5500
INT)
Log mode 43
: AOP configuration
Log mode 9
: Automatic replacement history
Log mode 20
: CPU5500 software state number/name
Log mode 21
: CPU5500 configuration parameters
Log mode 60
: Gives a list of DSP and FPGA software
version for each INT5500 connected to the
CPU5500.
Log mode 70
: Gives a list of DSP and FPGA software
version for each ID5500 connected to the
CPU5500.
Custom
: Special debug loggings (Televic R&D only)
 Interface test.