Micro couple is used to couple two microphones together, so that if
one microphone is activated, the other is automatically activated as
well.
This menu allows to activate/deactivate the coupling of
microphones.
The first three couples can be set by the central unit, more couples
(up to 10) need to be set in the software control suite.
Resetting the microphone system
If for any reason the system has to be reset, you can do this in the
Reset menu item. Only the microphone system will shut down and
start up again immediately. This will not affect the interpreter
system.
Accessing the microphone options
The microphone options are the Options menu item. The menu
item contains a number of menu items which allows the conference
system to be checked and to adjust some general settings. Two test
modes can check the sound of the delegate loudspeakers and can
check which microphones are connected to and initialized by the
CPU5500 central unit.
The Test Tone function is used to generate a test tone of 1kHz,
which is internally generated by microphone number 1 in the
system. This tone is set on the floor channel, on the delegate
loudspeakers and also on all free channels (where there is no
translation on-going) . The level of the tone is equal to the digital
level 0 dBFS (max), nominal level at –10 dBFS, and –20 dBFS as a
comfortable level to test the loudspeakers.
To Next Page
Loading...
