TCS5500
Page | 27
24. Serial Port COM2 connector
25. USB-FDD connector: service applications only
26. LPT1 parallel port: service applications only
27. AUX OUT / CONTROL port with D-SUB15 connector
28. Analog Output AUX OUT 1 with XLR-3M socket for
balanced output signal
29. Analog Input AUX IN 2 with XLR-3F socket for
balanced input signal (AUX IN 2)
30. Analog Input AUX IN 1 with XLR-3F socket for
balanced input signal (AUX IN 1)
Supplementary boards in the central unit
1. Serial board
This board is used to connect interface units with a RS232 protocol
to our system. For example: Camera operation, messenger control
panel, displays, Crestron, .etc. All these elements can by this means
be connected to our system.
2. Digital I/O board DIO
This board is used when the user wants to have a digital audio input
and/or output available. Thru the operational control suite, the
channel can be chosen to output, or to attribute the digital audio
input to a channel.
3. Opto coupler board OCB
The OCB board is used when there is need to couple multiple
rooms together into one virtual large room. The OCB takes care
that the central units are configured in a correct state of master or
slave.
The rack
Besides the central unit and the power supply, the following items
can be present in the rack:
EU5500 extension unit
To Next Page
Loading...
