10
Introduction
position. When you receive your teleset (and/or BEM24), the pedestal is in its
lowest position—flush against the bottom of the teleset.
To Open a Closed Pedestal on a teleset or BEM24:
1. Hold the top end of the pedestal in one hand and the frame of the unit
in the other.
2. In a quick movement, detach the top of the pedestal (you will hear a
sharp “click”).
3. Open the pedestal fully.
To Adjust the Pedestal (see the next illustration)
1. Grasp the rear of the pedestal base firmly with one hand while lifting
the rear portion of the teleset upward with your other hand.
2. While pivoting the teleset upward with one hand, pivot the teleset-
supporting arms upward with your other hand, while feeling for the
notches under the teleset. Notice there are three sets of notches under
the teleset corresponding to the three available positions.
3. When the teleset is at the desired height, find the closest pair of
notches and place the supporting arms in the notches. Press down
slightly on the teleset until you feel the supporting arms snap into
place.
To Next Page
Loading...
Need help?
General