20
Call Waiting (Camp-On)
To Place Call Waiting (Camp-On):
1. Dial the desired extension, or press a
designated DSS button. Hear a busy
tone.
2. Press the C
ALL WAITING button (if set
up) or dial the Call Waiting (Camp-On)
access code (8).
Hear a beep, followed by a hold tone.
3. Wait off-hook until the party answers.
If the dialed party is forwarded to an extension:
Use the “COM” feature to override forwarding (see “Intercom (COM)
Calling” on page 32).
Note:
“Call Waiting (Camp-On)” alerts a busy party to a waiting internal call with
one short beep tone, or a waiting external call with two short beep tones.
While camped-on, you receive a hold tone and a
STAND BY message on
your display. For “Call Waiting (Camp-On) Pick-Up,” see page 21.
If you hang up before your call is picked up, your Call Waiting (Camp-On) is
cancelled. If the called party hangs up without taking your call, they will
immediately receive a ring from your extension.
If you hear a triple beep tone after you dial (8), it means that the called
party is either using the phone but is not in conversation, or already has a
party camped-on. You are successfully camped-on, but the called party
does not know it. If you remain camped-on, the busy party receives
notification of your presence when they start a new conversation, or when
they pick up the camped-on call ahead of you.
P LUCKMANN
STAND BY