24-Port Managed Gigabit Switch
Step3: Power on the Switch and the self-test result will be shown
on the terminal device. After the self-test, enter the User
Name and Password (admin/admin by default for
administrator; user/user for common users) and press Enter.
The command prompt will be shown as below.
Figure 3-5 Switch Configuration Interface
3. By Telnet
Step1: Select Start on your computer and click Run.
Step2: In the appearing window enter the command: telnet
192.168.0.1 and press Enter. The following window will
be displayed as below.
12
To Next Page
Loading...
