Tenda TEG3224T - Layer 2 Features; Chapter 2 Connecting the Switch

24-Port Managed Gigabit Switch
1.2 Layer 2 Features
 Provides Store-and-forward architecture
 Supports up to 48Gbps backplane bandwidth
 Max. forwarding rate: 1488095pps per port (64 bit for each packet.)
 Supports 8K MAC address entries
 Supports jumbo frame forwarding
 Supports DSCP and 802.1p priority with 4 priority queues per port
 Provides frame buffer cache
 Supports 802.1QVLAN (1-4094) with up to 64 VLANs
 Supports IGMP V1 and V2
 Supports 802.1x port-based authentication
 Supports IEEE 802.3x for full-duplex and Backpressure for
half-duplex
 Supports ACL (Access Control List)
 Spanning Tree Algorithm Protocol for creation of alternative
backup paths and prevention of network loops, including
802.1w Rapid Spanning Tree (RSTP) and 802.1d Spanning Tree
 Supports link aggregation, including static aggregation mode
and LACP, and supports up to 12 Trunk groups and 16 Trunk
members per group
 Supports LLDP (Link Layer Discovery Protocol)
 Supports port mirroring
 Supports Multicast, Broadcast storm and unknown unicast
control
 Supports TFTP and HTTP firmware upgrade methods
 Supports CLI, Web, Telnet, SNMP V1 and SNMP V2c
management features
 Supports syslog
2