24-Port Managed Gigabit Switch
This page allows the user to inspect and configure the current LLDP
port settings.
1. LLDP Parameters
Tx Interval
The switch is periodically transmitting LLDP frames to its
neighbors for having the network discovery information
up-to-date. The interval between each LLDP frame is
determined by the Tx Interval value. Valid values are restricted
to 5 - 32768 seconds.
Tx Hold
Each LLDP frame contains information about how long time the
information in the LLDP frame shall be considered valid. The
LLDP information valid period is set to Tx Hold multiplied by Tx
Interval seconds. Valid values are restricted to 2 - 10 times.
Tx Delay
If some configuration is changed (e.g. the IP address) a new
LLDP frame is transmitted, but the time between the LLDP
frames will always be at least the value of Tx Delay seconds.
Tx Delay cannot be larger than 1/4 of the Tx Interval value.
Valid values are restricted to 1 - 8192 seconds.
Tx Reinit
When a port is disabled, LLDP is disabled or the switch is
rebooted a LLDP shutdown frame is transmitted to the
neighbor units for signalling that the LLDP information isn't
valid anymore. Tx Reinit controls the amount of seconds
between the shutdown frame and a new LLDP initialisation.
49
To Next Page
Loading...
Need help?
General
