24-Port Managed Gigabit Switch
Specify the action to take with a frame that hits this ACE.
Permit: The frame that hits this ACE is granted permission for
the ACE operation.
Deny: The frame that hits this ACE is dropped.
Rate Limiter
Specify the rate limiter in number of base units. The allowed
range is 1 to 15. Disabled indicates that the rate limiter
operation is disabled.
Logging
Specify the logging operation of the ACE. The allowed values
are:
Enabled: Frames matching the ACE are stored in the System
Log.
Disabled: Frames matching the ACE are not logged.
Please note that the System Log memory size and logging rate
is limited.
Shutdown
Specify the port shut down operation of the ACE. The allowed
values are:
Enabled: If a frame matches the ACE, the ingress port will be
disabled.
Disabled: Port shut down is disabled for the ACE.
4. Set up Source MAC and Source IP Binding
Strictly control the network traffic by only allowing incoming frames
that match the source IP and source MAC on specific port. Click
“Next” to enter the following window:
78
To Next Page
Loading...
Need help?
General
