THERA-Trainer BEMO - Page 40

User manual THERA-Trainer bemo EN
40
Article no. A007-661_Rev 2.0 - Last edited: 2020-06-02
Number of revolutions buttons:
 Press + button: THERA-Trainer gradually increases the number of revolutions.
 Press – button: THERA-Trainer gradually reduces the number of revolutions.
 Press and hold the button: increase or reduce number of revolutions continuously until maximum or minimum
is reached.
‒ Maximum number of passive revolutions: 100 rpm.
Direction of rotation button:
 Press button: THERA-Trainer reverses direction of rotation.
‒ The yellow arrow indicates the direction of rotation currently set.
1. Arrow up: forward direction of rotation
2. Arrow down: backward direction of rotation
‒ THERA-Trainer gradually reduces the number of revolutions to 0 rpm and resumes movement in the
opposite direction with a pre-set number of revolutions.
Exercising resistance buttons:
 Press + button: THERA-Trainer gradually increases exercising resistance for an active training session.
 Press – button: THERA-Trainer gradually reduces exercising resistance for an active training session.
 Press and hold the button: Increase or reduce exercising resistance continuously until maximum or minimum
is reached.
‒ Maximum exercising resistance: 10 Nm
‒ Adjustable in 0.5 Nm steps
Training time buttons:
 Press + button: THERA-Trainer increases the training time in minutes.
 Press – button: THERA-Trainer reduces the training time in minutes.
 Press and hold the button: Increase or reduce training time continuously until maximum or minimum is
reached.
‒ Factory setting: 15 minutes
‒ Adjustment range 1 – 180 minutes
Easy entry button:
 Keep the button pressed. Crank turns until button is released.
‒ Place feet in foot rests easily and comfortably one after the other when the foot rests are at the bottom.
‒ Press the easy entry aid button as often as required until feet are secured in foot rests.
 Press START button: Easy entry function ends.
Adjustment only possible before the training session is started. Button is inactive during training session.
The easy entry aid can also be used to get the feet out of the foot rests.
Spasm detection button:
 Press button: THERA-Trainer switches off spasm detection.
‒ Spasticity symbol is inactive.
 Press button again: THERA-Trainer switches on spasm detection.
‒ Spasticity symbol is active.
Training parameters display:
‒ Indicates training parameters during the training session.