WARNINGS
Read and understand this entire Manual and your employer’s safety practices before installing, operat-
ing, or servicing the equipment.
While the information contained in this Manual represents the Manufacturer's best judgement, the
Manufacturer assumes no liability for its use.
Plasma Cutting Power Supply, PAK
200
Operating Manual No. 0-5057
PCH/M 200 Torch
Published by:
Thermadyne Corporation
82 Benning Street
West Lebanon, New Hampshire, USA 03784
(603) 298-5711
www.thermal-dynamics.com
© Copyright 2008 by
Thermadyne Corporation
All rights reserved.
Reproduction of this work, in whole or in part, without written permission
of the publisher is prohibited.
The publisher does not assume and hereby disclaims any liability to any
party for any loss or damage caused by any error or omission in this
Manual, whether such error results from negligence, accident, or any
other cause.
Printed in the United States of America
Original Publication Date: June 9, 2008
Revision AB Date: October 8, 2008
Record the following information for Warranty purposes:
Where Purchased: ___________________________________
Purchase Date:______________________________________
Power Supply Serial #:_______________________________
To Next Page
Loading...
