3-7
3
DRIVE MOTOR SPROCKET 3.4
Replacement
The torque motor drive sprocket can be removed from the
loader without removing the drive motor from the final
drive housing.
1 Place the loader on a level surface, engage the park-
ing brake and shut off the engine.
2 Raise the loader securely from the ground and
remove the wheels on the side to be worked on.
3 Remove the inspection cover located between the
axle assemblies. (fig. C5059)
4 Disconnect the drive chains. Section 3-3, page 3-5
5 Remove the nut retaining the drive sprocket to the
drive motor. (fig. C5074a)
6 Using a puller, remove the sprocket from the drive
motor shaft. (fig. C5125)
7 Replace the drive sprocket in the reverse order
above. Apply Loctite 242 (blue) to the drive sprocket bolt
and torque the bolt to 275 ft lbs (373 Nm)
C5125
C5074a
C5074
C5059
Remove inspection cover
Disconnect chain links
Drive sprocket nut
Remove sprocket
To Next Page
Loading...
