Thomas 85 - Page 212

8
8-18
Controls
Vehicle: Steering direction and speed controlled by two hand operated control levers.
Hydraulics: Lift and bucket tilt are controlled by separate foot or hand controls. Auxiliary hydraulics controlled by
foot pedal or electric solenoid.
Engine: Hand throttle, key type ignition switch and shutoff.
Engine
Make and model ............................................................ ....................................................Kubota D722B
Cylinders ...............................................................................................................................................................................3
Cooling system ............................................................................................................................................................Liquid
Displacement ............................................................................................................................................43.8 cu in (722cc)
Horsepower (Gross)........................................................................................................................................................16.9
Max Torque............................................................................................................................................34 ft lbs (15.9 kg/m)
Fuel type .................................................................................................................................................Low Sulphur Diesel
Air cleaner................................................................................................................Replaceable dry cartridge w / Indicator
High Idle rpm .................................................................................................................................................................3140
Hydraulic System
Pump type ......................................................................................................................................................................Gear
Pump Capacity (theoretical)...................................................................................... 7.6 gpm (29 l/min)@2200psi(152bar)
Control valve ......................................................................................Series type with float on lift and detent on auxiliary
Filtration ............................................................................................................................................................... 10 micron
Hydraulic fluid ................................................................................................................................... 10W30 API Class, SJ
Control valve ......................................................................................Series type with float on lift and detent on auxiliary
Cylinders.................................................................................................Lift........................... .............................Tilt............
Type.............................................................................................Double acting..........................................Double acting
Qty per loader .................................................................................... 2..............................................................2............
Bore diameter .................................................................................. 2 in............................................................2 in........
Rod diameter ............................................................................... 1.125 in.....................................................1.125 in.....
Stroke ............................................................................................... 26 in..............................................................14 in..
Hydrostatic Transmission & Final Drive
Pump type ...........................................................................................................................Two in line, axial piston pumps
Pump displacement ..............................................................................................................................1.24 cu in (20.3 cm
3
)
Motor type .................................................................................................................................................................Geroler
Motor displacement .................................................................................................................................19 cu in (312 cm
3
)
System relief setting ................................................................................................................................2750 psi (190 Bar)
Final drive .............................................................................................Single roller chain running in oil bath to each axle
Drive chain size ........................................................................................................................................................ASA 60
Electrical
Alternator ........................................................................................................................................................................40 A
Battery .......................................................................................................................................................................1 x 12V
Type (BCI GROUP) .................................................................................................................................................V3478-5
Cranking Amps ................................................................................................................................................................550
Starter .............................................................................................................................................................12 V (1.2 kW)
Circuit breaker rating .....................................................................................................................................................30 A
SPECIFICATIONS 8.4