Receiver Descrambler - User Manual (release 7.3.1)
Setting the CAM Operation Mode
1. Use the and buttons to move the cursor to “CAM
Operation Mode”, then press the button.
2. Use the and buttons to change the mode (“Use
Decoded PIDs” or “Use Selected PIDs”), then press the
button to save the selection.
Note: Depending on the mode selection, the menus below the mode options will have changed.
Use Decoded PIDs
In the “Use Decoded PIDs” operation mode, the CAM will decrypt the audio and video programs that
are decoded by the unit. The Service Selection tuning determines the program that is sent to the CAM
for decrypting before the decoding takes place. Only the program used for decoding is sent to the CAM
no matter how many programs the CAM is capable of decrypting. If programs other than ( or in addition
to) the one being decoded is to be sent to the CAM for decryption, the “Use Selected PIDs” mode
should be used.
Use Selected PIDs
The “Use Selected PIDs” operation mode allows the selection of individual video and audio PIDs to
send to the CAM for decryption. There is no restriction on which PIDs can be selected (audio and video
PIDs need not be in the same program). The PIDs are selected from the PIDs that are available in the
PMT of the input. If there is no input PMT available, the selection of PIDs will not be possible. If a
selected PID is no longer listed in the input PMT, the Service that contained the PID will be listed
followed by a “*” indication. The Services with PIDs that are no longer in the PMT can be found on the
bottom of the Service list.
Once “CAM Operation Mode” has been set to “Use Selected PIDs”, use the following steps to configure
your unit to decrypt selected PIDs.
Note: It is only possible to decrypt more than one program at a time, if the CAM module supports
multiple program decrypting.
1. The Services that are sent to the CAMs are listed under
the “CAM1” or “CAM2” (with the CAM name if available).
2. Use the and buttons to move the cursor to the
program (Service) which contains the PIDs to be selected,
then press the button.
3. The video and audio PIDs that are available for that
Service in the PMT are listed.
CA Systems RDS1
CAM2:NagraVision
► SVC:816 ABCHE
Svc:892 CBCMH
CA Systems RDS1
►CAM2:NagraVision
SVC:816 ABCHE
Svc:892 CBCMH
CA Systems RDS1
►CAM Operation Mode:
Use Decoded PIDs
CAM2:NagraVision
To Next Page
Loading...
