THOMSON RD1000 - Page 57

THOMSON RD1000 / RD1002
Page 57
Receiver Descrambler - User Manual (release 7.3.1)
Edition 2 – October 2010
Clear All
This option will clear all IP addresses in the filter list.
1. Use the and buttons to move the cursor to
“Clear All”, then press the button.
2. Press the button one more time to clear all the IP
addresses in the list.
Reset Counters
This option will reset the counters on the status screen for the MPEG/IP card.
1. Use the and buttons to move the cursor to “Reset
Counters”, then press the button.
2. Press the button again to reset the counters.
Output Control
To configure this card as an output use the following steps:
1. Press the button.
Note: For dual units, select RDS1 or RDS2, then press .
2. Use the and buttons to move the cursor to the
“MPEG/IP” card of the specific slot (e.g. 1-4). Notice the
location diagram in the upper right corner of the screen
changes as the cursor moves by each card.
3. Press the button once to display the selection screen for
“Transmit 1” and “Transmit 2” of the MPEG/IP card.
 Output 
HD Video 2-1
►MPEG/IP 1-4
 MPEG/IP 1-3 
Receive 1
Receive 2
►Reset Counters
 MPEG/IP 1-4 2 
239.192.20.3
Add IP
►Clear All