6.2 Certifications and compliances
ITC500 / page 108
6.2 Certifications and compliances
Certifications and compliances
Category Standards or description
EC Declaration of
Conformity - EMC
Meets intent of Directive 89/336/EEC for Electromagnetic Compatibility.
Compliance was demonstrated to the following specifications as listed in the
Official Journal of the European Communities:
EN 61326 EMC requirements for Class A electrical
equipment for measurement, control and
laboratory use, including Class A Radiated and
Conducted Emissions
1,2,3
and Immunity.
1,2,4
IEC 61000-4-2 Electrostatic Discharge Immunity (Performance
criterion C)
IEC 61000-4-3 Radiated RF Electromagnetic Field Immunity
(Performance criterion B)
5
IEC 61000-4-4 Electrical Fast Transient / Burst Immunity
(Performance criterion C)
IEC 61000-4-5 Power Line Surge Immunity (Performance
criterion C)
IEC 61000-4-6 Conducted RF Immunity (Performance criterion
C)
IEC 61000-4-11 Voltage Dips and Interruptions Immunity
(Performance criterion C)
EN 61000-3-2 AC Power Line Harmonic Emissions
Complies with the Radiocommunications Act and demonstrated per EMC
Emission standard
1,2,3
:
AS/NZS 2064 Industrial, Scientific, and Medical
Equipment: 1992
Australia /
New Zealand
Declaration of
Conformity - EMC
FCC EMC
Compliance
Emissions comply with the Class A Limits of FCC Code of Federal Regulations
47, Part 15, Subpart B
1,2,3
.
1
Compliance demonstrated using high-quality shielded interface cables.
2
Compliance demonstrated with CAB400 cable installed at the LD Output port and CAB450 cable
installed at the TEC OUTPUT port.
3
Emissions, which exceed the levels required by these standards, may occur when this equipment is
connected to a test object.
4
Minimum Immunity Test requirement.
5
MOD IN port capped at IEC 61000-4-3 test.
EC Declaration of
Conformity - Low
Voltage
Compliance was demonstrated to the following specification as listed in the
Official Journal of the European Communities:
Low Voltage Directive 73/23/EEC, amended by 93/68/EEC