THORLABS ITC510 User Manual

3.1 IEEE488 Interface
ITC500 / page 61
[DCL] Device Clear
The command [DCL] will clear the input buffer and output queue. It will also reset the
parser unit and the execution unit
NOTE
The command [DCL] will set back all units connected to the IEEE488 bus.
[SDC] Selected Device Clear
The command [SDC] will clear the input buffer and output queue. It will also reset the
parser unit and the execution unit
NOTE
In contrast to the command [DCL] the command [SDC] will only set back
the device addressed.

THORLABS ITC510 Specifications

General

Brand	THORLABS
Model	ITC510
Category	Controller
Language	English