FFS2000 Series Chapter 10: Shutting Down and Storage
Page 60 TTN047338-D02
Chapter 10 Shutting Down and Storage
10.1. Shutting Down
The following procedures should be followed when shutting down the FFS2000 Series system:
Turn off the power to the splicer (i.e., ON/OFF switch on the back panel) and the external power supply,
and shut down the FFS3 software.
Turn off the argon gas supply at the regulator.
Replace the tops on the soak and clean containers.
Ensure that the recoat molds are properly cleaned before placing tissues between the plates.
Close the tops on the FHBs and splice station, and recoat block.
10.2. Storage and Transportation
Please retain the original packaging for the FFS2000 Series splicer and use for all transportation of the unit.
When packaging the splicer for storage or transportation, the following precautions are necessary.
Do not store or transport the splicer with the soaking or cleaning containers filled.
WARNING
Leakage of solvent or cleaner could seriously damage the unit.
Make sure the acrylate injector port is empty, particularly if it is stored near a fluorescent light source. If it
is stored when not empty, the material may cure (harden) in the port. To empty the injector, open the
recoat mold top. Turn the injection plunger clockwise to force the UV acrylate material out of the injection
port and onto the recoat mold plate. Wipe up the acrylate as it is ejected with a soft lint-free cloth.
FHBs must be positioned on the transfer jig at the splice station.
Disconnect the recoat mold injector.
Disconnect all gas and electrical connections.
Make sure that the foam is positioned properly and carefully close the carton.
!
!
To Next Page
Loading...
Need help?
General
