FFS2000 Series Chapter 11: Maintenance
Rev B, July 21, 2017 Page 77
Figure 67 Flushing the Recoat System
11.6. Soak / Clean Station
11.6.1. Replace Indicator Bulb
Unscrew the red indicator cap, and remove the bulb. Replace only with a Thorlabs supplied or recommended
bulb. Replace the indicator cap.
11.6.2. Replace Solvents
WARNING
Danger of shock and damage to the unit if it is left connected to the power supply! Turn off power,
and disconnect the power supply.
Soaking Station
Tightly screw on the soaking container. While pushing down on the container top, unscrew the flange clamps ½
turn to release the container (Figure 68). The soaking container can now be lifted straight up and out.
Properly dispose of the old fluid and clean the container. Replace with clean fluid and screw the top on tightly.
Replace the soaking container and turn the flange clamps ½ turn to secure the container.