100
12.1.2. Output settings
Default
OUT1
ON
–20.0 dB
(OUT 1 – 8)
0 dB
OFF
ALL FLAT
OFF
01 (When EQ = ON and EQ band number = 01)
0 dB (When EQ = ON and EQ band number = 01)
1.5 (When EQ = ON and EQ band number = 01)
31.5 Hz (When EQ = ON and EQ band number = 01)
OFF
OFF
OFF
OFF
0 (When DELAY = ON)
–20 dB
Setting Item
Output Channel Selection
Channel Control
Channel Gain
Channel Name
BASS/TREBLE
Loudness Compensation
Speaker Parameter Presetting
EQ
EQ Band Number
Gain
Q
Center Frequency
HPF
LPF
Compressor
Delay ON/OFF
Delay Time
Paging output volume
[Settings when the AN-001T is not used]
ZP-001T: PRIORITY 3 (When paging function is ON)
Modules except the ZP-001T: PRIORITY 2 (When paging function is ON)
OFF (When the ducker function is ON)
0 dB (for all the assigned output channels)
Ducker Priority Level
Ducker Attenuation Level
Assigned Output Level
[Settings when the AN-001T is used]
BYPASS
–10 dB
OFF
OUT1
OFF
OUT1 (When the monitor ON/OFF setting is ON)
–6 dB
0 dB
20 sec
3:3
0 dB
ANC Operation ON/OFF
Input Sensitivity
Phantom Power
ANC-Activated Output
Monitor ON/OFF
Monitor Output Channel
Lowest Output Level
Highest Output Level
Sampling Time
Gain Ratio
Reference Level
To Next Page
Loading...
