Toa A-9120DHM2 - Page 93

93
(D4) Scene memory erasure (when ERASE is set)
E R A S E < - 0 1 S C E N E 1
(D5) Scene memory bank number to be recalled at power on
P O W E R O N < - LAST S C E N E
Designate either the Scene memory bank number to be automatically recalled at power-on, or "LASTSCENE."
When LASTSCENE is selected, the Scene memory recalled last before power-off is automatically recalled
when power is turned on. When the Scene memory bank number (one of 01 – 32) is selected, the Scene
memory saved there is automatically recalled when power is turned on.
Note
To retain the set parameters, be sure to save them in the Scene memory. Unless otherwise saved, all the set
parameters are abandoned when the AC power supply is shut off or when the other scene is loaded.
LASTSCENE (default), 01 – 32
Setting Range
Erase the saved Scene memory.
Pressing the Enter key erases the Scene memory in the designated memory bank number.
To cancel erasure execution, press the Escape/Back key.
After erasure completion, each set parameter is restored to the factory default setting.
01 – 32 (default: 01)
Setting Range