Install the thrust washer in the direction as shown.
Be sure to use a Honda genuine part
(stainless steel).
Bend the pin ends as shown to
secure the nut.
PROPELLER THRUST WASHER
GEAR CASE
SIDE
PROPELLER WASHER
TORQUE:
1 N·m (0.1 kgf·m, 0.7 lbf·ft)
Tighten the castle nut to the specified
torque. If the split pin cannot be set,
tighten the nut additionally until the split
pin can be set.
MAX. TORQUE:
44.1 N·m (4.5 kgf·m, 33 lbf·ft)
PROPELLER CASTLE NUT (18 mm)
3-BLADE PROPELLER
(Optional part)
SPLIT PIN (4.0 mm)
SPLIT PIN (4.0 mm)
PROPELLER
SIDE
To Next Page
