2.2. Setting up tanks
16
l Pulses/revolution: Set how many pulses there are per revolution
of the pump shaft.
Monitor drive
Monitor drive is used to monitor operations for the seeder without
application rate control. The application rate must be set by
physically changing the drive settings on the metering unit for each
tank.
Drive settings
l Dump valve: Use this option if the proportional valve has its
own dump valve on each channel.
l Pressure sensor: Use this option if a tank pressure sensor is fitted
to the seeder.
l Min voltage: Sets the minimum output voltage at zero pressure.
This value is read from the pressure transducer.
l Max voltage: Sets the maximum output voltage at maximum
pressure. This value is read from the pressure transducer.
l Max pressure: Sets the maximum pressure for the voltage
pressure sensor.
To Next Page
Loading...
