Topcon Apollo ISOBUS UT - Default Chapter; Table of Contents

x
Table of contents
Chapter 1 – Introduction 1
1.1. Console / ECU interface 2
Chapter 2 – Seeder Settings 3
2.1. Setting up the seeder 3
2.2. Setting up tanks 7
2.2.1. Granular tank settings 8
2.2.2. Liquid/NH3 tank settings 12
2.3. Setting up external options 17
2.4. Setting up tank timing 19
2.5. Setting up wheel factor 21
2.5.1. Manual entry of wheel factor 21
2.5.2. Automatic calibration of wheel factor 21
2.6. Setting up fans 24
2.7. Setting up geometry 25
2.8. Setting up speed 27
2.9. Settings for blocked heads 29
2.10. Viewing operating history 31
2.11. Selecting seeder brand 32
2.12. Managing implement profiles 33
2.12.1. Creating an implement profile 33
2.12.2. Selecting a profile 33
2.12.3. Copying a profile to / from USB 34
Chapter 3 – ECU Setup 37
Chapter 4 – Product Settings 39
4.1. Setting up products 39
Chapter 5 – Calibrating the Tanks 43
5.1. Manual entry of calibration factor 44
5.2. Automatic calculation of calibration factor 45
5.2.1. Calibrating a single granular tank 45
5.2.1. Calibrating multiple granular tanks 48
5.2.1. Calibrating a liquid tank 51
Chapter 6 – Area Test 55
6.1. Performing the area test 55