7.2. LED behavior
60
7.2. LED behavior
Tank keys:
l Tank disabled (buttons 3 and above on a 2 tank implement): All
LEDs are dark.
l Tank is on: Green LED (Tank and master switch is on. Product is
flowing.)
l Tank is off but active: Amber LED (it is selected and ready to run
but master is off and not doing prime/preload).
l Otherwise: Red LED
Special case one: During calibration, the tanks that have green or
amber LEDs on also have the red LED flash in sequence. On a
single tank system the red LED of tank 1 would flash, on 2 a tank
system the red LEDs on tanks 1 and 2 would flash alternately and
on a 3+ tank system the red LEDs would flash on keys 1, 2, 3, …
1, 2, etc. While this is happening the amber or green LED
indicate the state of the tank.
Special case two: The Cabin keypad will not have the flashing
LEDs described above if the master switch is not controlled by
the keypad.
Master switch ( ):
l Master switch is on: Green LED
l Cabin keypad and master switch is not controlled by the keypad:
All LEDs are dark.
l In normal mode (no calibration), master switch is off, can be
turned on: Amber LED
l In normal mode (no calibration), master switch is off, can’t be
turned on: Red LED
l In calibration mode, master switch is off, any tank is active
(selected): Amber LED
l In calibration mode, master switch is off, no tank is active
(selected): Red LED
To Next Page
Loading...
