7.1. Keypad setup
58
2.
Select to configure the In Cabin keypad, or select to
configure the On Frame keypad.
l Keypad ID: If more than one keypad is installed, this selects
which keypad is installed in the cabin and which is on the frame.
Each keypad has a unique identity number. Select to
identify which keypad is installed in the cabin and which is
installed on the seeder frame. When selected, the LEDs on that
keypad flash.
In cabin keypad:
l Keys marked 1 – 8 turn tanks on and off. Note that Apollo
ISOBUS UT seeder supports four tanks.
l Key A: Tank rate increase. The amount the rate changes by is
entered in the INC/DEC setting on the Product Settings screen.
Refer to Setting up products, page 39.
l Key B: Tank rate decrease.
l
Key Reset ( ): Blockage check. Runs granular product to the
openers for the time period entered in Preload Time (see Setting
up tank timing, page 19). (This is only available for proportional
drive tank types. It is not available for linear actuator, regulator
To Next Page
Loading...
