9.1. Configuring advanced settings
74
section). Disabling TC SC prevents tanks being turned on and off
via section control.
l
Switch display : Select to switch the ISOBUS UT display.
Use this option if the vehicle has multiple ISOBUS UT terminals.
l
Factory reset : Select to perform a factory reset of the Apollo
ECU. A warning message appears on screen to confirm the reset.
Note: Factory reset deletes all the settings and data stored on the
Apollo ECU. Use the factory reset option only when
recommended by Topcon support or a service technician.
l Switch TC:Select to switch the ISOBUS task controller that will
be used to control this ECU. Use this option if the vehicle has
multiple ISOBUS task controllers.
l
Firmware upgrade : Select to upgrade the Apollo ECU
firmware. Refer to Upgrading ECU firmware, page 75.
l
Serial port access : Select to enable serial port access to the
Apollo ECU. This option is useful for service technicians and
should be disabled for normal seeder operation.
l
Monitoring mode : Selecting places all drives into
monitoring mode (disables rate control). Note: To re-enable rate
control, drive type settings must be manually reconfigured. Refer
to Setting up tanks, page 7.
Note: The Apollo ECU must be powered off to carry out any repair
or maintenance.
To Next Page
Loading...
