EasyManuals Logo

Topcon DS Series User Manual

Topcon DS Series
202 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #187 background imageLoading...
Page #187 background image
180
28. SPECIFICATIONS
(8 + 10ppm X D) mm (over 200 to 350m)
(15 + 10ppm X D) mm (over 350 to 1,000m)
(ISO 17123-4 : 2001)
Measurement mode Fine measurement (single/repeat/average)/Rapid measurement
(single/repeat)/Tracking (selectable)
Measuring time (fastest time under good atmospheric conditions
*2
, no compensation,
EDM ALC at appropriate setting, slope distance)
Fine measurement: less than 1.5 sec + every 0.9 sec or less
Rapid measurement: less than 1.3 sec + every 0.6 sec or less
Tracking measurement: less than 1.3 sec + every 0.4 sec or less
Atmospheric correction
Temperature input range: - 30 to 60°C (in 0.1°C step)/ - 22 to 140°F (in 0.1°F step)
Pressure input range: 500 to 1,400 hPa (in 0.1hPa step)
375 to 1,050 mmHg (in 0.1mmHg step)
14.8 to 41.3 inchHg (in 0.01inchHg step)
ppm input range: -499 to 499 ppm (in 0.1 ppm step)
Prism constant correction -99 to 99 mm (in 0.1 mm step)
0mm fixed for reflectorless measurement
Earth curvature and refraction correction
No/Yes K=0.142/Yes K=0.20 (selectable)
Sea level correction No/Yes (selectable)
*1 : Slight haze, visibility about 20 km, sunny periods, weak scintillation.
*2 : No haze, visibility about 40 km, overcast, no scintillation.
*3 : Figures when both the elevation and depression angles of the laser beam are within 15° and
the instrument is facing the 360° Prism.
*4 : Figures when the laser beam strikes within 30° of the reflective sheet target.
*5 : Figures when using Kodak Gray Card White side (reflection factor 90%) and brightness level
is less than 5,000 lx.
*6 : Figures when using Kodak Gray Card White side (reflection factor 90%) and brightness level
is less than 500 lx.
*7 : Face the prism toward the instrument during the measurement with the distance at 10 m or
less.
*8 : Accuracy is (5 + 2 ppm X D) mm for distance range 0.3 to 0.66m.
*9 : Figures will change depending on the target reflection factor, weather conditions and location
conditions.
Auto Tracking
Measuring method Pulse laser transmitter and image detector with co-axial optics
Signal source (emitted beam) infrared laser diode (980nm)
Class 1
(IEC60825-1 Ed. 2.0: 2007/FDA CDRH 21 CFR Part 1040.10 and
1040.11 (Complies with FDA performance standards for laser
products except for deviations pursuant to Laser Notice No.50, dated
June 24, 2007.))
Viewing angle ± 45’
Measuring range V: Elevation angle 90° (when handle is attached: 70°),
Depression angle 41°
*11
Maximum Auto Tracking measurement range
*12
360° Prism ATP1/ATP1S: 2 to 600 m (1,960 ft)
*3

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Topcon DS Series and is the answer not in the manual?

Topcon DS Series Specifications

General IconGeneral
BrandTopcon
ModelDS Series
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals