Managing the Radio Modem
P/N 7010-1004
3-13
reinitialization. The transmitting modem will send the service
word to the receiving modem in every ‘sndtime’ seconds.
• Advanced parameters:
• H/W Version – queries the hardware version of the board.
• Net ID – sets network ID. A radio link can only be
established between modems having the same Net ID. It can
be the number in the range from 0 (default) to 255.
• Rep Net ID – sets a new Rep Net ID parameter for Repeater
type. A modem with Repeater type set carries out
retransmission with other Rep Net ID that is different from
receiving Net ID. In this mode, it is possible to set different
Net IDs for received and retransmitted signals. It can be the
number in the range from 0 (default) to 255.
• Hot Lock, s – sets time to keep synchronization after signal
drop. It can be 5, 10, 20, 30 (default), or 40 seconds.
• Save Power – enables/disables (default) Power Saving mode.
The transmitter and receiver must be set to the same mode.
4. When finished configuring the radio modem, always disconnect
from TRU before exiting to prevent conflicts with serial port
management.
If needed, launch TRU and set up the receiver to run as an RTK
Base station or RTK Rover.
The service word does not affect the differential
corrections (RTCM or CMR messages) in any way.
If the parameter is set to zero, the service word is
not be used in data transmission.
This page is intentionally left blank
To Next Page
Loading...
Need help?
General
