Index
HiPer Pro Operator’s Manual
Index
modem 2-27–2-31
power 2-5
receiver 2-15
using PC-CDU 2-15
Connect receiver to computer
unable to connect
2-12
using Bluetooth 2-11
using PC-CDU 2-13
using RS232 cable 2-12, 2-32
using USB cable 2-12
Customer support 5-12
D
Data recording auto-start 2-24
Delete files 4-13–4-14
Differential corrections
LQ field
3-17
Disconnect 2-27
Download
BTCONF
2-32
files 4-10–4-12
firmware 4-22–4-26, 4-27–4-28
FLoader 4-22
indicators 4-12
OAF 4-16
Dual frequency 1-2
E
EIM 4-8–4-9
LED blink indications 4-9
Elevation mask 2-21
External components 1-13
External power 2-3, 2-4
F
File creation mode 2-22
File name prefix 2-16, 2-21
Files
Bluetooth module
4-27
delete 4-13–4-14
download 4-10–4-12
flash 4-23, 4-24, 4-27, 4-28
power board 4-23, 4-25
RAM 4-23, 4-24, 4-27, 4-28
select 4-11
Firmware
check version
4-21
files 4-23, 4-27
load 4-22–4-26, 4-27–4-28
Flash file 4-23, 4-24, 4-27, 4-28
FLoader 1-8, 4-22
FN key 4-3
change baud rate 4-4
data recording 4-3
information modes 4-3
FN key mode 2-23
See also FN key
I
Information mode
See also Receiver modes
EIM
4-8
extended 4-8
normal 4-8
sleep 4-19
STAT LED 4-8
zero power 4-20
Initial data collection dynamic mode
2-24
Install
BTCONF
2-32
FLoader 4-22
Modem-TPS 2-26
OAF 4-16
USB driver 2-10
Internal antenna 1-10, 1-13
offset 3-2
setup 3-2
Internal batteries 2-2
charge 2-9
status 2-10
Internal components 1-10
K
Kinematic survey 3-8
See also Stop and Go survey
To Next Page
Loading...
