Getting Acquainted
P/N 7010-0681
1-13
The Li-Ion batteries used in the HiPer Pro should run at no less than
98% capacity after 500 charging cycles. These batteries do not need
to be drained before recharging.
A battery charger (AC adapter) is included with the standard package.
See Appendix A for technical specifications on the battery.
External Components
The HiPer Pro casing includes panels for radio antenna attachment, a
user interface, a power port, and ports for configuration.
Bottom Panel
The bottom panel of the HiPer Pro receiver has the receiver serial
number, receiver part number, receiver type (Base or Rover), and
antenna reference point (ARP).
Radome
Figure 1-4 on page 1-14 shows the radome components:
• Internal antenna – Location of GPS/GLONASS internal antenna.
• Modem antenna connector – Modem antenna connector used for
internal modem RF connection. This is a BNC female connector
for spread spectrum modems.
Table 1-2. Operating Times
Modem Mode HiPer Pro
TX mode ON (1W) 11 hours
RX mode ON 14 hours
Standby mode 13 hours
OFF 16 hours
To Next Page
Loading...
