Topcon HiPer Pro - Chapter 3 Setup and Survey; Receiver Setup Procedures

P/N 7010-0681
Chapter 3
3-1
Setup and Survey
This chapter describes:
• Receiver setup
• RTK Base station setup
• RTK Rover setup
• Basic surveying with the HiPer Pro receiver
The HiPer Pro package use one receiver as the Base station and the
other as the Rover station.
Receiver Setup
To set up the receivers, you must:
1. Configure the receivers as shown in Chapter 2.
2. Set up the Base and Rover stations. See “Step 1: Set up the
Receiver” on page 3-2.
3. Measure the antenna height. See “Step 2: Measure Antenna
Height” on page 3-2 for internal antennas.
4. Begin collecting data. See “Step 3: Collect Data” on page 3-4.
All receivers include an internal, micro-strip antenna able to capture
L1/L2 signals from GPS and GLONASS satellites.