Topcon HiPer Pro - Turning On;Off the Receiver; Power Management

Powering the Receiver
P/N 7010-0681
2-5
Turning On/Off the Receiver
To turn ON the receiver, press and hold the green power key for about
0.5 seconds and release it.
NOTICE
NOTICE
If the receiver does not turn on, it may be in Zero Power
Mode. See “Zero Power Mode” on page 4-20 for more
information.
To turn OFF the receiver, press and hold the green power key for
more than one and less than four seconds (until both the STAT and the
REC LEDs are off). This delay (about 1 second) will prevent the
receiver from being turned off by mistake.
Power Management
You can use Topcon’s PC-CDU software to manage your receiver’s
power. The complete description of PC-CDU exceeds the scope of
this manual, but can be found in the
PC-CDU User’s Manual. The latest copy of this software and the
manual can be downloaded from the TPS website.
To access the dialog box controlling the power settings for the
receiver, take the following steps:
1. Connect your receiver and computer. See “Connecting the
Receiver and a Computer” on page 2-10 for this procedure.
2. Once connected, click ConfigurationReceiver.
3. Select the Power Mode drop-down list to set the desired power
source (Figure 2-2 on page 2-6). Current Mode displays the
current power source.
• Auto – receiver automatically selects the power source
• Mix – receiver automatically detects and consumes power
from the source with the largest voltage
• Battery A – receiver consumes power from battery A
• Battery B – receiver consumes power from battery B