Introduction
HiPer Pro Operator’s Manual
1-8
Power Supply/Charger
The Power Supply/Charger unit (p/n 22-034101-01) is used to charge
the internal batteries when connected to a grounded outlet; it can also
be used as an external power source (Figure 1-3). This unit converts
the alternating current (AC) normally supplied from an electrical
outlet to a direct current (DC) used to charge the batteries and power
the receiver.
• input voltage – between 100 and 240 V AC
• frequency of input power – between 50 Hz and 60 Hz
• output voltage – 12 V DC@2.5 A (30 W)
Figure 1-3. Power Supply/Charger
Software
Standard receiver software includes:
• PC-CDU – controller software that can run on a Windows®-
based computer.
• FLoader – Topcon’s firmware loader; available on the Topcon
website.
• BTCONF – Topcon’s Bluetooth® wireless technology module
configuration program; available on the Topcon website.
• Modem-TPS – Topcon’s radio modem configuration software;
available on the Topcon website.
• Topcon Tools – optional; Topcon’s post-processing software.
To Next Page
Loading...
