Topcon HiPer Pro - Page 154

Index
HiPer Pro Operator’s Manual
Index
Range 1-6, C-1
Real-time kinematic 1-2
See also RTK 1-2
REC LED 4-3
green 4-3
orange 4-3
red 4-3, 4-4
Receiver modes 4-19
See also EIM
See also Normal Mode
extended
4-8–4-9
sleep mode 4-19
zero power 4-20
Receiver setup 3-2
Recording interval 2-21
Reset key 4-3
Rover
kinematic setup
3-8–3-9
RTK setup 3-14–3-16
RS232 connection parameters 2-13
RTK 1-2, 3-10
base station setup 3-10
package contents 1-6
rover setup 3-14
RX LED 4-8
and modem antenna 5-11
blink pattern 4-8
green 4-8
no light 4-8
orange 4-8
S
Security parameters 2-35
Serial number 3-6
Set baud rate
115200
2-11, 2-14, 4-22, 5-8
38400 3-12, 3-16
9600 4-4
SHMM 1-15, 1-16, 3-2
Slant height measure mark
See SHMM
Sleep mode
4-19
Software 1-8
FLoader 1-8, 4-22
Modem-TPS 1-8
PC-CDU 1-8, 2-15–2-18,
2-20–2-25
Pinnacle 1-8
radio configuration 1-8
TopSURV 1-9
Start/stop data recording 4-3
STAT LED 4-2, 4-8
blink pattern 4-2, 4-8–4-9
EIM 4-8
green 4-2
orange 4-2
red 4-2
Static survey 3-5–3-7
configuration 3-6
MINTER parameters 3-6
Stop and Go survey 3-8
configuration 3-8
Survey configuration
static
3-6
stop and go 3-8
Surveying
kinematic
3-8
RTK 3-10
static 3-5–3-7
stop and go 3-8
Switch information modes 4-3
System range C-1
T
Test 1-5, 4-8, B-3
EIM 4-8–4-9
TopSURV 1-9
Turn on/off 2-5
U
UHF usage C-1
Unable to connect 2-12
Uninstall
BTCONF
2-32
Modem-TPS 2-27
USB connection parameters 2-14
USB driver 2-10