Topcon HiPer Pro - Page 6

Table of Contents
HiPer Pro Operator’s Manual
ii
Option Authorization File (OAF) ........................................ 1-16
Chapter 2
Configuration .......................................................... 2-1
Powering the Receiver ........................................................ 2-2
Internal Batteries ........................................................... 2-2
External Batteries .......................................................... 2-3
Battery Charger ............................................................. 2-4
Turning On/Off the Receiver ........................................ 2-5
Power Management ...................................................... 2-5
Charging Internal Batteries .................................... 2-9
Checking Internal Battery Status ........................... 2-10
Connecting the Receiver and a Computer ........................... 2-10
Establishing a Wireless Connection ............................. 2-11
Establishing an RS232 Cable Connection .................... 2-12
Establishing a USB Connection .................................... 2-12
Establishing a PC-CDU Connection ............................. 2-13
Receiver Configuration ....................................................... 2-15
MINTER Configuration ...................................................... 2-19
Radio Configuration ............................................................ 2-26
Setting the Radio Link .................................................. 2-28
Configuring Radio Channels ........................................ 2-30
Bluetooth Module Configuration ........................................ 2-32
Collecting Almanacs ........................................................... 2-37
Chapter 3
Setup and Survey ................................................... 3-1
Receiver Setup ..................................................................... 3-1
Step 1: Set up the Receiver ........................................... 3-2
Step 2: Measure Antenna Height .................................. 3-2
Step 3: Collect Data ...................................................... 3-4
Surveying with the Receiver ............................................... 3-5
Static Survey ................................................................. 3-5
Kinematic (Stop and Go) Survey .................................. 3-8
Real-time Kinematic Survey ......................................... 3-10
Set up an RTK Base Station ................................... 3-10
Set up an RTK Rover ............................................. 3-14