Ethernet Connection
23
P/N: 1011907-01
Configuration
Set Up a Static IP Address For the Laptop
When setting up the static IP address of the laptop, the first three numbers of the IP address must match the
receiver’s IP address. For example, if the receiver’s IP address is 10.5.57.200, the computer IP address must be
10.5.57.xxx.
1. Open the Network and Sharing Center on your laptop.
2. Change your Local Area Connection TCP/IPv4 settings to match the receiver (Figure 21).
Figure 21: Laptop Internet Protocol Settings
3. Enter the IP address for the primary board (see “View Receiver IP Addresses” on page 22).
4. If needed, enter the Default gateway address.
5. Click OK to apply the changes to your laptop.
To Next Page
Loading...
