Topcon MR-2 - Configure the Receiver; Configure the Receiver as a Base; Configure the Antenna

Configure the Receiver
27
P/N: 1011907-01
Configuration
Configure the Receiver
The following base and rover configurations are recommended for the most common applications; however, you
can select configuration parameters as needed.
Configure the Receiver as a Base
The following describes how to configure the receiver as a base.
Configure the Antenna
1. In TRU, click DeviceApplication ModeReceiver ManagingReceiver Settings. The Receiver
Settings screen appears (
Figure 26).
Figure 26: TRU – Receiver Settings
2. Click Tracking & Positioning. The Tracking & Positioning screen appears (Figure 27 on page 28).
3. Click the Antenna tab, and set the GNSS Antenna type to External.
Do not make other changes without consulting the TRU Online Help , embedded in the software.