Configuration
20
P/N: 1011907-01
Configuration
Configuring the receiver enables you to change GPS settings, verify satellite tracking, etc. To do this, you’ll need
to use the Topcon Receiver Utility (TRU) software available the myTopcon Website
(https://www.topconpositioning.com/support). See
“Install the Topcon Receiver Utility (TRU)” on page 18 for
more information.
The sections in this chapter describe how to use TRU to configure the receiver. Once this is accomplished, you can:
•
Set up GPS parameters and other settings
•
Monitor the receiver’s GPS status
•
Log raw data to a file
•
Load a new OAF, firmware, and other configuration files to the receiver
Connect The Receiver to TRU
The steps in this section work with receivers that have one or two boards.
1. Connect the receiver and computer as described in “Step 2: Connect to a Computer or Display Unit and RTK
Correction Source” on page 13.
2. Start TRU on the computer. The TRU main screen displays (Figure 17). Initially the tools are inactive.
Figure 17: TRU – Main Screen
3. Click DeviceApplication ModeReceiver Managing.
4. Click DeviceConnect. The Connection Parameters screen appears.
To Next Page
Loading...
