Configure the Receiver
36
P/N: 1011907-01
Configuration
Figure 41: Receiver Settings – Positioning
4. Set the following parameters then click OK to return to the Receiver Settings screen.
•
Positioning Mode
– Select a positioning mode for the receiver.
•
Enable Solutions
– Select solutions used in position computation.
– Standalone – Where the receiver computes 3D coordinates in autonomous mode without using
differential correction.
– Code Differential – Where the rover receiver computes the current relative coordinate in differential
mode using only pseudo ranges.
– RTK Float – Where the Rover receiver computes the current relative coordinates in differential mode
using both pseudo ranges and phases; however, with a float solution, the phase ambiguity is not a
fixed integer number and the “float” estimate is used instead.
– RTK Fixed – Where the rover receiver computes current relative coordinates, with ambiguity fixing, in
differential mode.
•
DION
– Select the mode in which the DION engine will operate.
– Off – The DION engine is disabled.
– Local – The DION engine provides precise positioning with respect to a starting point.
– Smooth – The DION engine provides smoothed estimates of absolute positions using refined delta
positions from carrier phase processing.
5. Click OK to return to the Receiver Settings screen.
To Next Page
Loading...
