Topcon SP-1P - Power Save Recovery and Panel Adjustment

33
PREPARATIONS
RECOVERY FROM POWER SAVE STATUS
This instrument adopts the power save system for saving electric power. When the machine is not
operated for a set time, the control panel becomes a screensaver.
1 Tap the control panel or operate the control lever.
In a few seconds, the measurement screen is displayed and photography is enabled.
ADJUSTING THE CONTROL PANEL POSITION
The control panel may be positioned by swinging and tilting the monitor to your desired position.
Touching the control panel controls operations including chinrest movements, alignment and pho-
tography.
NOTE
The time to start the power save status can be changed in the initial setting
"Auto power save" (see page 59).
NOTE
• The layout of OD/OS is reversed according to the position of the control
panel.
• The moving direction by tapping is changed according to the position of
the control panel.
• The instrument moves in the direction which continued pressing on a con-
trol panel at any control panel position.
(L)
(L)
(
(
(
L
)
L)
)
(L)
L)
L
L)
L
L)
L
)
)
)
L
L
L
L)
L
(L)
L
L)
L
(L)
L)
L)
L
)
)
)
)
(L)
)
)
(L)
)
)
(L)
L
)
()