Need help?Do you have a question about the Topcon X63 and is the answer not in the manual?
General| Brand | Topcon |
|---|---|
| Model | X63 |
| Category | Touch Panel |
| Language | English |
Details the X63 system components and its 3D control capabilities.
Describes the X62 system components and its 2D control functionality.
Explains how to orient TS-1 sensors based on mounting surface and marker direction.
Provides guidance on mounting the body sensor parallel to the boom pivot.
Details recommended mounting locations and precautions for the boom sensor.
Refers to boom sensor mounting for secondary boom installations.
Guides on mounting the TS-1 sensor on the excavator stick for optimal performance.
Covers the installation of the bucket sensor, including protection and orientation.
Describes an alternative mounting location for the bucket sensor on the dog-bone.
Explains the mounting procedure for a tilt bucket sensor.
Details the process of accurately measuring and inputting machine dimensions for calibration.
Guides on setting up sensor IDs and physical orientations in the 3DMC software.
Step-by-step guide for calibrating the body sensor's pitch and roll.
Instructions for calibrating the boom sensor's pitch and roll using a laser.
Details calibration for a secondary boom sensor, referencing primary boom calibration.
Procedures for calibrating the stick sensor's pitch and roll.
Steps for calibrating the bucket sensor's pitch and roll.
Describes the procedure for calibrating the bucket edge.
Explains how to calibrate multiple buckets for use with the system.
Outlines the calibration process for a dog-bone mounted sensor.
Details the calibration steps for a tilt bucket sensor.
Explains the importance and procedure for proper sensor communication termination.
Describes how to adjust sensor filtering levels for optimal performance.
Checks if all sensors are working and communicating by moving machine parts.
Verifies elevation accuracy using 3DMC simulator mode and a laser.
Measures and verifies the distance from the main antenna to the boom pivot.
Details methods for verifying the distance from the aux antenna to the boom pivot.
Checks for constant offsets when comparing curled vs. extended positions.
Adjusts the main antenna height value in 3DMC to correct elevation bias.
Notes that verifying aux antenna height is not critical for elevation measurement.
States that boom pivot height verification is not necessary for elevation accuracy.
Instructions for mounting the LS-B10W laser receiver and bracket on the stick.
Guides on determining the receiver's position and angle to the stick center line.
Verifies the accuracy of the LS-B10W laser receiver using the Zero to Laser function.
Verifies sensor accuracy by measuring bucket positions at various extensions.
Checks body sensor accuracy by comparing positions on a cross slope.
To Next Page
