©Tormach® 2021
Specifications subject to change without notice.
Page 7 UM10753: 8L Operator's Manual (Version 0321B)
For the most recent version, see tormach.com/support
TABLE OF CONTENTS
6.2 Bring the Machine Out of Reset 44
6.2.1 About Reset Mode 44
6.3 Reference the Machine 44
6.3.1 About Referencing 44
6.4 Jog the Machine 44
6.4.1 About Jogging 45
About Continuous Velocity Jogging 45
About Step Jogging 45
6.4.2 Jog Controls Reference 45
Jogging in PathPilot 46
Jogging with the Keyboard 46
Jogging with the (Optional) JogShuttle 46
6.5 Change the Spindle Speed Range 46
6.6 Load Material into the Spindle 47
6.7 Load G-Code 48
6.7.1 Transfer Files to and From the Controller 48
6.8 Set Work Offsets 49
6.8.1 About Work Offsets 49
6.9 Set Tool Geometry Offsets 50
6.9.1 Touch Off the Tool Geometry Offsets 50
Touch X 50
Touch Z 51
6.9.2 About Tool Offsets 51
6.9.3 Import and Export the Tool Table 51
Import a .csv File 51
Export the Tool Table as a .csv File 51
6.10 Operate the Coolant Pump 52
6.10.1 About Coolant 52
MACHINE MAINTENANCE
53
7.1 Maintenance Safety 54
7.1.1 All Maintenance Procedures 54
7.1.2 Swarf Maintenance Procedures 54
7.1.3 Coolant Maintenance Procedures 54
7.2 Maintenance Schedules 54
7.2.1 Daily 54
7.2.2 Weekly 54
7.2.3 Monthly 54
7.2.4 Semi-Annually 54
7.2.5 Annually 54
7.3 Clean the Coolant System 54
To Next Page
Loading...