4.1 BEFORE YOU BEGIN
1. Inspect the item(s):
l Photograph any damage that may have occurred
during shipping.
l Note any damage on the delivery receipt before
signing for the shipment.
l Verify the received goods against the packing list.
If there is any damage or shortages, you must contact
Tormach within 30 days of receipt. Create a support
ticket with Tormach Technical Support at
tormach.com/how-to-submit-a-support-ticket for
guidance on how to proceed.
2. Before uncrating your machine, collect the following
tools and items:
l 14 mm wrench
l Adjustable wrench
l Flat-blade screwdriver
l Hammer
l Metric hex wrench set
l Pallet jack
l Phillips screwdriver
l Pry bar
l Razor blade
l Safety eyewear that meets ANSI Z87+
l Snips
l Work gloves
4.2 MOVE THE CRATE
WARNING! Transportation and Lift Hazard: Before
moving the machine, you must confirm that all
persons are clear of the area below the machine.
Qualified professionals must transport, lift, and move
the machine. Moving parts can entangle, pinch, or cut
you, causing death or serious injury.
Verify that the ground surface is smooth and clean of
debris, and then use a pallet jack to move the pallet(s) to
the desired installation location.
Note: If the ground is not smooth, you may
need to use a forklift (or similar lifting
equipment rated for uneven surfaces) to move
the pallet(s).
4.3 UNPACK THE CRATE
CAUTION! Sharp Objects Hazard: Before opening the
shipping crate, you must put on work gloves and
safety eyewear that meets ANSI Z87+. If you don't,
the shipping crate and steel straps could cut you,
causing serious injury.
1. Put on work gloves and eye protection.
2. Cut the shipping straps on the outside of the machine's
shipping box with snips. Discard the shipping straps.
3. Cut open the machine's shipping box with a razor blade,
and then remove the shipping box from the shipping
crate. Discard the cardboard.
4. Open and disassemble the machine's shipping crate with
a hammer. Start with the top and follow by the four
sides. Set aside the wood from the machine's shipping
crate; we recommend using it later in this procedure to
remove the bandsaw from the pallet.
5. Remove the plastic machine wrap and discard. When
finished, the contents will look similar to the following
image.
Figure 4-1: Bandsaw after opening the shipping crate.
©Tormach® 2024
Specifications subject to change without notice.
Page 20 UM10825: AF50+ Autofeed Bandsaw Operator's Manual (Version 0324A)
For the most recent version, see tormach.com/support
4: INSTALLATION
To Next Page
Loading...
