Tormach AF50+ - Controls Overview; Machine Controls; Program Controls

5.1 CONTROLS OVERVIEW
To safely and effectively operate your machine, you must
become familiar with its basic controls.
5.1.1 Machine Controls
The following controls energize the machine's control
electronics:
l
Main Disconnect Switch On the front of the electrical
cabinet.
l
Cycle Start Button On the control panel.
Figure 5-1: Machine controls.
l
Coolant Switch On the control panel.
l
Pause Button On the control panel.
l
Emergency Stop Button On the control panel.
5.1.2 Program Controls
The control panel has the following controls, used to switch
between automatic and manual mode, and to set the
parameters for machine operations:
l
Up and Down Arrow Buttons On the control panel.
For information, see "Set the Number of Cuts"
(page35).
l
Stroke Button On the control panel.
For information, see "Set the Number of Cycles"
(page35).
Figure 5-2: Program controls.
©Tormach® 2024
Specifications subject to change without notice.
Page 28 UM10825: AF50+ Autofeed Bandsaw Operator's Manual (Version 0324A)
For the most recent version, see tormach.com/support
5: SYSTEM BASICS