Tormach AF50+ - Coolant Pump Doesnt Work

10: TROUBLESHOOTING
©Tormach® 2024
Specifications subject to change without notice.
Page 60 UM10825: AF50+ Autofeed Bandsaw Operator's Manual (Version 0324A)
For the most recent version, see tormach.com/support
10.2.1 Coolant Pump Doesn't Work
l
Problem The coolant pump doesn't work.
l
Cause The coolant pump may not be receiving power, or there may be faulty components.
You May Need
To...
Probability How-To Steps Need More?
Turn on the
coolant pump.
High Examine the coolant pump's switch. If necessary, turn it
to the ON position.
For information, see "Controls
Overview" (page28).
Fill the coolant
tank.
High Examine the coolant level in the coolant tank. If
necessary, fill it to an appropriate level.
For information, see "Machine
Maintenance" (page45).
Examine the
coolant pump.
Medium Examine the coolant pump for blockages or mechanical
damage. If necessary, remove blockages or replace the
coolant pump.
Create a support ticket with
Tormach Technical Support at
tormach.com/how-to-submit-a-
support-ticket for guidance on how
to proceed.
Examine the
main motor.
Low Verify that the motor that drives the blade (main
motor) is powered on and operating. If it's not on, turn
it on.
Create a support ticket with
Tormach Technical Support at
tormach.com/how-to-submit-a-
support-ticket for guidance on how
to proceed.
Replace the
main fuse.
Low Examine the main fuse. If necessary, replace it. For information, see "Electrical
Schematics" (page111).