8: MANUAL OPERATION
12. On the operator panel, push the green Cycle Start (CS)
button twice, which activates the blade.
13. Move the blade feed lever down (in the Go position), and
adjust the feed as necessary.
14. On the front of the machine, above the blade feed lever,
locate the feed adjustment knob. Use the feed
adjustment knob to set the cutting rate.
©Tormach® 2024
Specifications subject to change without notice.
Page 43 UM10825: AF50+ Autofeed Bandsaw Operator's Manual (Version
0324A)
For the most recent version, see tormach.com/support
To Next Page
Loading...
